Troubleshooting: Shocker Pairing

Shocker Pairing Mode

Make sure you shocker is in Pairing Mode when trying to send a command. It can be any command, at any intensity, and any duration. Recommended command is Vibrate at 2-5 seconds.

Caixianlin Shocker

For the Caixianlin shockers that is done by holding the power button down for 2-3 seconds. It will beep and start to flash its led fast. While it is flashing fast send your command.

Petrainer

Depending on what Petrainer model you have this might be a bit different. For the 998DR you should just be able to press the power button once, that should put it into pairing mode by default.

If anyone has more information for other models feel free to contribute or leave a message on our discord

Hub Radio Transmitter Pin (RFTX Pin)

Your Hub's RFTX GPIO Pin might not be set correct. This can be especially the case for DIY. See here for more information